24. SERVICE PROCEDURE 24.4.7 CHECK FAN BELT TENSION, ADJUST Checking The belt should normally deflect by 6 - 10 mm when pressed with the finger (with a force of approx. 6 kg) at a point midway between the alternator pulley and fan pulley. Fan pulley Crankshaft pulley Adjusting 1. Loosen bolts and nuts 0, 0 and 0. 2. Turn nut 0 clockwise, then move alternator 0 to adjust the belt tension so that the deflection is approx. 6 mm when pushed with a force of 6 kg. 3. Tighten the bolts and nuts 0, 0 and 0 to fix alternator 0 in position. 4. Check each pulley for damage, wear of the V-groove, and wear of the V-belt.
In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 5. If any belt has stretched and there is no allowance for ad- justment, or if there are cuts or cracks on any belt, replace both belts at the same time. 6. When the new belt is set, readjust it after operation for an hour. 3-56