Komatsu — 24.4.9 CHECK, CLEAN ADDITIONAL FUEL STRAlliER

24. SERVICE PROCEDURE 24.4.8 DRAIN WATER AND SEDIMENT FROM FUEL FILTER 1. Open the engine side cover on the left side, loosen drain plug 0 at the bottom of the filter, and drain the fuel together with the water and sediment accumulated at the bottom of the tank. 2. Tighten drain plug 0. 3. Loosen the knob of feed pump 0 and operate it 50 - 60 times up and down. This will bleed the air. 4. Push in the knob of feed pump 0 and tighten it. 24.4.9 CHECK, CLEAN ADDITIONAL FUEL STRAlliER Open the inspection cover at the bottom of the fuel tank. Tighten the fuel supply valve, then remove the cap, and clean the strainer and strainer case. The strainer forms one unit with the cap.

Set the strainer in the case, then tighten the cap. After installing, open the fuel supply valve. 3-57