Komatsu — 24.7.1 CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT

24. SERVICE PROCEDURE 7. Remove mounting bolt 8 of filter 0, then remove cover 0. 8. Take out element 0,. 9. Clean the removed parts and the inside of the case, then install a new element. Always use a genuine Komatsu element. 10. Install drain plug 0. 11. After installing, loosen air bleed plug 0, start the engine, and when oil spurts out, tighten the plug. 12. Close filter cover 0, and tighten bolt 0. 13. Install frame seal 0. NOTICE When installing seal 8, always close filter cover @ first. If the filter cover is closed after the seal is installed, the seal will be damaged. 14. Add the specified amount of engine oil through the oil fil- ler 0. For details of the oil to use, see “20.

USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. Seal is hitted J T Filter cover F175W 15. Check that the oil is at the specified level. For details, see “24.4 EVERY 250 HOURS SERVICE.” 3-70