Komatsu — 24.7.6 CHECK ENGINE VALVE CLEARANCE, ADJUST

24. SERVICE PROCEDURE 24.7.2 CLEAN, CHECK TURBOCHARGER (D65P, D65EX, PX ONLY) Contact your Komatsu distributor for cleaning or inspec- tion. ELEMENT 24.7.3 CLEAN ENGINE BREATHER on the cam fol- 1. Wipe off all the dirt around the breather lower cover. 2. Remove the breather. flushing oil, then 3. Wash the whole breather in diesel oil or blow it dry with compressed air. 4. Replace the breather O-ring with a new part, coat with en- gine oil, and install it. 24.7.4 CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced.

24.7.5 CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours. 24.7.6 CHECK ENGINE VALVE CLEARANCE, ADJUST Contact your Komatsu distributor for inspection or adjust- ment. 3-71