Komatsu — 11.3 CONTROL LEVERS AND PEDALS

11. EXPLANATION OF COMPONENTS 6. PARKING LEVER When the machine is parked, always set the parkmg lever to the LOCK position. This lever is used to apply the parking brake. REMARK If the parking lever is set to the LOCK position when the directional and steering lever is at the forward or reverse po- sition, the directional and steering lever is automatically re- turned to the N position. When starting the engine, check that the parking lever is at the LOCK position. If it is not at the LOCK position, the en- gine cannot be started. 7. SAFETY LEVER (For blade control lever) A WARNING When leaving the operator’s compartment, set the safety lever securely to the LOCK position.

If the con- trol lever is not locked, and it is touched by mistake, this may lead to a serious accident. If the safety lever is not placed securely in the LOCK position, the control lever may not be properly locked. Check that the situation is as shown in the diagram. When parking or servicing the machine, be sure to lower the blade and set the safety lock in the LOCK position. This is the locking device of blade control lever. When the safety lever is set to the LOCK position, the TILT, LOWER, and FLOAT controls are locked. If it is set to the LOCK position when the blade control lever is at the FLOAT position, the blade control lever is automati- cally returned to the HOLD position. 2-25