Komatsu — 11.16.6 CLEANING AIR FILTER

11. EXPLANATION OF COMPONENTS 11.16.4 INSPECTION DURING OFF-SEASON Even during the off-season, run the compressor at low speed for several minutes once a week to prevent the loss of the oil film at the lubricated parts of the compressor. (Run the engine at low speed and set the temperature control lever at the central position.) REMARK When the ambient temperature is low, if the compressor is suddenly run at high speed, it may cause failure of the cqm- pressor. Note that the system is set so that the compressor will not run when the cooler switch is turned on if the am- bient temperature is less than 2 - 6.5X.

11.16.5 PROCEDURE FOR REPLACING RECEIVER Replace the receiver once every two years. After replacing the receiver, add compressor oil. Turn the re- ceiver at an angle and measure the oil remaining inside the receiver, then add the same amount of oil (Denso Oil 6) to fill the receiver. REMARK Depending on the condition of use, the replacement inter- val may be shorter. REMARK If the receiver is used when the desiccant has exceeded the water absorption limit, the refrigerant circuit may become clogged and cause failure of the compressor.

l If the receiver is left for more than 15 minutes with the blind cover removed, the moisture in the air will be ab- sorbed, and this will reduce the life of the desiccant. If you remove the blind cover, connect the piping quickly, evacu- ate the system and fill with refrigerant. Precautions when replacing receiver l When removing the refrigerant from the refrigerant circuit, release it gradually from the low pressure side to prevent oil from flowing out. 11.16.6 CLEANING AIR FILTER If the air filter for the FRESH or RECIRC air intake becomes clogged, the cooling or heating capacity will drop. To prevent this, clean the air filter with compressed air once a week.

For details of the cleaning method, see “24.1 WHEN REQUIRED”. 2-46