12. OPERATION a (1) Automatic preheating Turn glow switch 0 to the AUTO position. When it is turned to the AUTO position, preheating is automatically carried out according to the ambient tem- perature. Lamp 0 lights up during the preheating oper- ation. When the preheating is completed, lamp 0 will go out. AUTO I (2) When the preheating is completed, turn the key in starting switch 0 to the START position to start the engine. OFF START (3) After starting the engine, return glow switch 0 to the OFF position. AUTO I REMARK If the engine can not start after automatic preheating, start it using manual preheating. l (1) Manual preheating Turn glow switch 0 to position I or II.
Lamp @ lights up during the preheating operation. When the preheating is completed, release the switch. The key will then return automatically to the following position. From position I, it will return to AUTO From position II, it will return to OFF The preheating times are as shown below. -1 o’c to -20°C I 30 seconds -20x to -30°C 45 seconds If the preheating time is too long or too short, the engine will not start easily. Observe the correct preheating time. 2-60