Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WARNING never pour it into idle for 10 minutes until the ° C (194 ° F). valve (2) and plug water filler up to the bottom of density, see the COOLANT the coolant, run the engine at 4 - 29 Antifreeze is toxic. When open the d rain valve and the drain plug, be careful not to get water containing a it gets in your eyes, flush your eyes with large amount of fresh water and se e a doctor at once. When changing the coolant or draini ng the coolant from the radiator before c arrying out repairs, ask a spe handle any coolant containing anti freeze, or contact your Komatsu distributor. Antifreeze is toxic, so to the ground surface.

drainage water ditches or drain it on The Supercoolant is already diluted with distilled water, so it is not flammable. (For details of the di "COOLANT AND WATER FOR DI LUTION (PAGE 4-7)". Check the density with a coolant tester Prepare a container that is a larger than the specified amount of coolant, then drain the coolant i Prepare a hose to use when filling with coolant. 1. Stop the engine. 2. Loosen radiator cap (1) slightly the cap. 3. Prepare a container to catch the (2) at the radiator left lower porti of the cylinder block to drain th 4. After draining the water, close d fill with city water. 5.

When the radiator is full, start th Keep the engine running at lo water temperature reaches mo 6. After flushing, stop the engine, (3), then close it again after all 7. Add Supercoolant through the the filler port. For details of the Supercoolan 8. DENSITY TABLE. To remove the air contained in low idle for 5 minutes, then run idle. (When doing this, leave th 9. Stop the engine. About 3 minut the water filler, then close radia