hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual 11.2.2 Releasing the parking brake and the HP valves In order to tow the compaction roller, short-circuit the hydraulic circuit between the traction pump and the hydraulic traction motors. Access the HP valves from the left side of the engine compartment (in the direction of motion). You need a socket head wrench (size WW 4 ) to loosen the HP valves ( 1 ) and ( 2 ). Unscrew the protecting caps. Use the socket head wrench to screw in the adjusting spindles until they are level with the valve housing. 4 mm socket head wrench 1 2 Fig.

63 Opening the HP valves 11.2.3 Deactivating (releasing) the parking brake In order to tow the compaction roller, you need to release the parking brake in the rear axle and in the drum via the hand pump ( 5 ). The hand pump ( 5 ) is installed in the engine compartment (on the right side, in the direction of motion). Actuate the push-button ( 4 ). Put a pipe extension into the pump actuation ( 3 ). Build up pressure by manually pumping, which releases the parking brake und causes the corresponding light on the dashboard to go out. Remove the pipe extension. 3 4 5 Fig. 64 Deactivating the parking brake 11.2.4 Carrying out the towing process 55 DANGER Risk of death!

If the compaction roller is not properly secured against rolling, you must not carry out any of the work described below. WARNING Towing distance and speed  The compaction roller may only be towed within the working zone.  The towing distance is to be kept as short as possible and may not exceed 500 meters / 550 yards!  Before starting the towing process, make sure the necessary preparations concerning the driving hydraulics and the parking brake have been completed.  Set the towing vehicle in motion very slowly (max. towing speed 1 km/h / 0.62 mph).