Operating & maintenance manual Always make sure the compaction roller is attached at both tie-down points on the front ( 1 ) / rear ( 2 ) in order to set up a towing connection. First of all, secure the compaction roller against rolling by establishing the connection with the towing vehicle. Remove the wheel chocks and the additional safety equipment used for preventing the compaction roller from rolling. The towing distance is to be kept as short as possible. 1 2 Fig.65 Tie-down points 11.2.5 After towing Closing the HP valves:
After the towing process, the hydraulic circuit between the traction pump and the traction motor must be closed and the parking brake needs to be put in working order again. Access the HP valves from the left side of the engine compartment (direction of motion). In order to activate the HP valves ( 1 and 2 ), you need a socket head wrench (WW 4). Use the wrench to loosen the adjusting spindles until they have reached their initial position. Attach the protecting caps. 1 4 mm socket head wrench 2 Fig. 66 Closing the HP valves 56 DANGER Risk of death!
Immediately after completing the towing process, secure the compaction roller against rolling by means of the wheel chocks and further equipment, if required.