hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual Step 3: Mounting the 2nd & the 3rd pad foot segment Lift the second segment at the lifting lug ( 7 ). Place it on the top of the smooth roller drum ( 5 ), adjust it and connect it to the first segment ( 2 ) by bolting them together at the junctions ( 9 ). Use clamps ( 10 ) to attach the loose edge of the second segment to the smooth roller drum ( 5 ). Make sure there is enough space between the mounted segments and the roller frame. Back up the compaction roller until the bare part of the surface of the smooth drum ( 1 ) points upward, rendering it possible to mount the third segment (2). Attach the third segment ( 2 ).

Connect it to the first and the second segment ( 2 ) by bolting them together at the junctions ( 9 ). Tighten all screws at the junctions evenly ( 9 ) along the entire width of the roller ( B ). Repeatedly drive the compaction roller forward and backward so the segment junctions point upward. Check all screw connections at the junctions ( 9 ) and tighten them (tightening torque: 660 Nm) . Install the corresponding pad foot scrapers ( 11 ) in order to use the drum as a pad foot roller ( 6 ). 10 9 10 5 7 B 11 6 11 Fig. 83 Mounting the pad foot segments 69 NOTICE After approx. 10 hours of operation, check all screw connections again (9). If necessary, tighten them. Tightening torque: 660 Nm.