Operating & maintenance manual 15.1.3 Filling procedure: Pure water In order to fill the tire with water, use industrial water. The filling procedure is identical to the one with antifreeze additive as described above. 15.1.4 Emptying the tires Lift the compaction roller at the rear axle by means of a sufficiently dimensioned hydraulic jack. Turn the tire ( 1 ) until the charge valve ( 2 ) is in the lowest position. Slowly unscrew the valve core ( 3 ). Due to the overpressure in the tire, water will pour out of the tire down to the level of the charge valve (6). Extend the vent pipe of the composite valve (7) by means of a thin rubber hose ( 9 ).
In order to remove the remaining quantity of water from inside the tire, screw the composite valve ( 7 ) onto the charging valve ( 2 ) and charge with compressed air ( 8 ). The compressed air drives the remaining water out of the tire via the rubber hose ( 9 ) until it finally leaks from an opening at the side of the composite valve. As soon as the tire is empty, attach the valve core ( 3 ) and fill the tire ( 1 ) with compressed air. Prescribed pressure: 1.6 bar (for standard tires). 1 2 6 8 3 7 9 3 71 Fig. 85 Emptying the tires WARNING Risk of injuries! • Antifreeze may leak from the tire while its tire pressure is being checked. • This can lead to chemical burns.
Wear protective clothing to protect your skin!