hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual 15.1.5 Filling procedure: Using the ”Hanauer Maus“ In order to fill or empty a tire by means of the so-called “Hanauer Maus“ (“Mouse of Hanau“), carry out the following instructions: Use a sufficiently dimensioned hydraulic jack to lift the compaction roller at the rear axle. Turn the tire ( 1 ) until the charge valve ( 2 ) is in the top position. Slowly screw off the valve core ( 3 ). Screw the fill valve ( 10 ) into the charge valve ( 2 ). Screw a hose line ( 4 ) onto the fill valve ( 10 ). The air escapes from the tube and the opening at the side of the fill valve ( 10 ). Twist off the fill valve ( 10 ) and tighten the valve core ( 3 ).

At the end of the filling procedure, unscrew the fill valve ( 10 ) and screw in the valve core ( 3 ). Fill the tire ( 1 ) with compressed air until the required pressure of 1.6 bar (for standard tires) has been established. The filling procedure is complete as soon as a constant jet of water exits the opening. 3 10 3 4 Fig. 86 Filling the tires 15.1.6 Checking the tire inflation pressure 15.1.7 Mounting the tires 72 In order to check the tire inflation pressure, the charge valve (2) needs to be in the top (“12 o‘clock“) position. 2 1 • Drive the compaction roller forward and backward to establish this position of the tires (1). • Unscrew the safety cap of the charge valve.

• Press the charge valve until the saline solution stops leaking from the charge valve (2). • Attach the tire gauge and check the tire inflation pressure. Fig. 87 Checking the tire inflation pressure • If necessary, adjust the tire pressure. M NOTICE A fr d aterial damage! lways empty the tire and make sure no water and saline solution can leak om the charge valve before checking the tire inflation pressure. Moisture estroys the tire gauge. Type of tires Inflation pressure Note Standard tires 1.2 to 1.6 bars (17.4 to 23.2 psi) Water filling Special tires Please contact the tire manufacturer for information on the required pressure! Water filling M NOTICE    aterial damage!

Have tires replaced or mounted by an authorized Hyundai dealer or a trained expert only. In order to prevent the tire from sliding on the wheel rim, the tire must not be mounted with the aid of lubricants. Tightening torque of the wheel nuts: 500 Nm.