4 HAND CONTROLS 4.3 Angle Adjustment After changing the control cable the control lever angle will need to be verified and / or adjusted to provide oper- ator comfort and proper pedal travel clearance.Ensure the loader is parked on a level surface. 1 Make sure the cable ends are screwed onto the cable threads a minimum of 3/8’’ (6mm). 2 Place an angle finder on the top of the main tubing to find the base measurment. Take note of the reading. 3 Place the angle finder on the control lever as shown (fig. C3877). Note the reading. The correct angle is 8º + / - 1º. 4 Adjust the angle by moving the cable nuts up or down on their mount.
Adjustment may be made at the front and / or the rear of the cable. (fig. C3848 and fig. C3877) 5 Tighten all cable nuts and jam nuts on the cable ends. (fig. C3833 and fig. C3848) 6 Cycle the control levers to check for travel clearance. 7 Reconect the throttle to the control lever plate. Fasten the control lever boots to the cab. Replace seat and hydro- static shield. (fig. C3876) C3876 C3876 4-14