Control Lever Replacement 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Never work under the boom arms without the boom supports engaged. 2 Remove the seat and hydrostatic shield. 3 Remove control lever plates and boots. Disconnect throttle if necessary. (fig. C3876, C3832) 4 Remove cotter pins from the lever base ass’y and cable and remove the clevis pin. (fig. C3848) 5 Loosen the cable nuts and remove cable from mount on control lever. 6 Remove bolts from control rod. 7 Remove mounting bolts for control lever. (fig. C3847) 8 Remove control lever saving the plastic sleeve. Replace if necessary. 9 Replace all parts in reverse order.
Cycle the control lever after installation to check for binding and travel clearance. Check control angles, wheel speed and track- ing to ensure optimum performance. C3876 Control Lever Cover Control Handle 4 C3832 NOTE: If the loader is equiped with optional electronic accessories operated by control handle mounted switches, the control handle switch wiring will need to be discon- nected and transferred to the new steering lever. If the control lever functions are sloppy due to excessive wearing of the swivel bushing, the swivel assembly may need replaced. HAND CONTROLS 4.3 Control Cable C3848 C3848 Remove The Mounting Bolt C3847 C3847 4-15