. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS "Working Mode Selector Switch (PAGE 3-24)". NOTICE 3 - 137 2. To complete the warm-up operation of the hydraulic equipment more quickl y, set the working mode to P mode (heavy-duty f the procedure for setting the working mode, see mode). For details o 3. Move lock le ver (2) slowly to the FRE E position (F), then raise the bucket fr om the ground. 4. Turn fuel co ntrol dial (3) to a point mi dway between low idling (MIN) and fu When the work eq uipment is retracted, take ca re that it does not in terfere with the machine 5.
Move right work equipment control lever (4) slowly i n the direction to p ull in the bucket (D). Ope rate the lever to th e end of its travel a nd hold it in position for 3 6. Move right work equipment control direction to push out the bucket (C). Operate the lever to the end of its tra vel and hold it in position for 30 seconds. 7. Next, move l eft work equipment contr ol lever (5) slowly i n the direction to pull in the arm (B). Operate the lever to the end of its travel and hold it in p osition for 30 seconds. 8. Move left wo rk equipment control leve r (5) slowly in the direction to push out the arm (A ).
Operate the lever to the end of it s travel and hold it in posi tion for 30 second 9. Repeat the operation in Steps 5 to 8 f