Komatsu — AFTER STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS temperature monitor (6) is displaying temperature monitor is not displaying the is displaying low temperature), repeat Steps 5 to 9 until the display is the correct temperature. (A) Display when temperature is correct: Monitor background vibration. If 3 - 138 10. the correct temperatur If the hydraulic oil tem correct temperature (it (B) Display when temp 11. Check that engine co (C) is blue erature is low: Monitor backgr 11. the correct temperatur (A) Display when temp (B) Display when temp If it displays low tempe the engine until eng displays the correct te For details of the proc 3-135)". 12.

Check that the hydrau the correct temperatur (A) Display when temp kground (C) is blue the engine until eng displays the correct te ine coolant temperature monitor (1) mperature. edure, see "Engine Warm Up (PAGE lic oil temperature monitor and engine For details of the proc 3-135)". Check that the hydrau 12. coolant temperature temperature, then ch monitors on the machi Engine coolant tem temperature Hydraulic oil temp temperature Charge level monito Engine oil pressure Engine pre-heating Engine coolant tem range Hydraulic oil tempe range Fuel gauge (12):

Ind Fuel level monitor (1 coolant temperature temperature, then ch monitors on the machi monitor are displaying the eck that all the gauges and ne monitor are in the following correct caution status. perature monitor (1): Displays correct erature monitor (6): Displays correct r (7): OFF monitor (8): OFF monitor (9): OFF perature gauge (10): Indicator in green rature gauge (11): Indicator in green icator in green range 3): Displays appropriate level Fuel level monitor (1 3): Displays appropriate level 13.

Check for abnormal e xhaust gas color, noise, or vib any problem is found, contact your Komatsu distribut In 32 °F)], even displays the correct tempe rature, carry out additional Ste p 14 to warm up all the hydraulic e