Komatsu — LOADING AND UNLOADING WITH TRAILER

. OPERATION TRANSPORTATION LOADING AND UNLOADING WITH TRAILER WARNING Always obey the following when loading or unloading the machine from a trailer. Select firm, level ground when loading or unloading the machine. 3 - 177 Maintain a safe distance from the Always turn the auto-deceleratio If the auto-deceleration switch i move. Always set the travel speed switc edge of the road. n switch OFF (cancel). s left ON, the machine may suddenly h to low speed (Lo), run the engine at low idling, and operate the mach ine slowly when loading or unloading.

In cold areas, carry out the warmi ng-up operation thoroughly and make sure that the engine speed is sta ble before carrying out the loading or unloading operation. Never correct your steering on the ramps. There is danger that the machine may tip over. If necessar y, drive off the ramps or back on to the trailer and correct the direction. It is dangerous to use the work equipment for loading and unloading operations. Always use ramps. ate any lever except the travel lever. When on the ramps, do not oper The center of gravity of the mac hine will change suddenly at the joint between the ramps and the traile r, and there is danger of the machine losing its balance.

Travel slowly over this point. If it is necessary to swing the wor k equipment on the trailer platform, the footing is unstable, so be extrem ely careful that the machine does not tip over. If the work equipment is installed to the machine, pull the work equipment in, and operate slowly to prevent the machine from losing its balance. Position a flagman to give gui dance to prevent the machine from ure safety in the operation. coming off the ramps and to ens Always check that the sliding do or of the cab is at the LOCK position, regardless of whether the door is open or closed.

If the door is opened or closed when the machine is o n the ramps or on the trailer platform, there is danger that the operating effort for opening or closing the door may suddenly change. Always observe the following preca utions strictly for the ramps and trailer platform. Use ramps with ample width, leng th, thickness, and strength and install them securely at a maximum slo pe of 15°. the piled soil fully and take action to psing. he machine tracks and ramps before When using piled soil, compact prevent the slope face from colla Remove all mud and dirt from t starting in order to prevent the m achine from slipping on the ramps.

Be sure that the ramp surface is clean and free of water, snow, grease, oil, or ice. These may cause the machine to slip.