Komatsu — LOADING AND UNLOADING WITH TRAILER

. OPERATION TRANSPORTATION 3. Turn the travel speed selector switch to low speed travel (Lo lamp lights up). Press travel speed selector switch (5) to switch the travel speed. The travel speed (Lo, Hi) is displayed on the travel speed monitor (6). 3 - 178 When loading or unloading, alwa ys use ramps or a platform. Proceed as Loading l ground only. the edge of a road. 1. Load and unload on firm leve Maintain a safe distance from 2. Apply the trailer brakes secur tires to prevent the trailer from Set left and right ramps equally spaced to the left a Make angle of installation ramps bend a large am machine, put blocks under bending. 1.

Load and unload on firm leve Maintain a safe distance from 2. Apply the trailer brakes secur ely, then put blocks (1) under the tires to prevent the trailer from moving. (2) parallel to each other and Set left and right ramps nd right of center (3) of the trailer. (4) a maximum of 15°. If the ount under the weight of the the ramps to prevent them from 4. Turn auto-deceleration switc h (7) OFF and operate the fuel control dial to set the engine Each time auto-decelera switches OFF J ON J OF When auto-deceleration s auto-deceleration monitor ( control dial to set the engine Each time auto-decelera speed to low idling. tion switch (7) is pressed, it F in turn.

witch (7) is turned OFF, the 8) goes out. 5. When loading, set the work equipment at the front and the blade at the rear, with the un set parallel. dercarriage and upper structure 6. Before moving onto the ramp s, make sure that the machine is positioned in a straight line with the ramps and that the ches that of the trailer. th the ramps and travel slowly. centerline of the machine mat Align the direction of travel wi Lower the work equipment as far as possible without causing interference. When on the ramps, operat e only the travel lever. Do not operate any other lever.