Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing.Even in the areas where freezing is not an issue, the use of antifreeze COOLANT is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for two years or 4000 hours. As a basic rule, we do not recommend the use of any COOLANT other than SUPERCOOLANT (AF-NAC).

If you use another COOLANT, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of COOLANT, always keep the density of COOLANT between 30% and 68%. When selecting COOLANT, investigate the lowest temperature in the past and decide the density for the COOLANT from the COOLANT density table below. When actually deciding the density for the COOLANT, set it about 10 ° C (18 ° F) below lowest temperature. The density must be over 30% at least.

If the density of obtained COOLANT is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, please contact your Komatsu distributor. 4 - 22 Immediately after th e engine is stopped, the coolant is at a high t emperatur e an d th e radiator is under high internal pressure. If th e ca p is r emoved to drain th e coolant i n this condition, there is a hazard o f burns. Wait for t he temperature to g o down , then turn the cap slowly t o release t he pressu re before removin g it. Cleanin g is carried o ut with the engine ru nning.

When standing u p or leaving the operator's seat, set the lock lever to the LOCK position . For details o f startin g the engi ne, see "B EFORE STARTING ENGI NE (PAGE 3-110)" a nd "STARTING ENGINE (PAGE 3-129)" in the OPERATION sec tion. The engine i s operat ed when w ashing, so it is d angerous if the m achine moves whe n you are standing behind it. Never stand behind t he machine when the engine is r unnin g.

Stop t he machine on level ground whe n cleaning o r changin g the coolant Clean the inside of t he cooling system, change the coolant a ccording to t he t able below Coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine SUPERCOOLANT (AF-NAC) Every two years or every 4000 hours whichever comes first