Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 24 5. Check that the cooling w ater temperature has gone d own enough to make it possible to touch the radiator cap surfac e by hand, then turn radiator c ap (6) slowly until it contacts the sure. stopper to release the pres 6. Following this, push radiat or cap (6), turn it until it contact s the 7. stopper, then remove it. Place a container to catch the coolant under the drain hose installed to drain valve (7) the engine cylinder block. and under coolant drain plug (8) on 8. Open drain valve (7) at the bottom of the radiator and drai n the water. Remove drain plug (8) in th e cylinder block and drain the w ater. 9.

After draining the water, clo se drain valve (7) and tighten drain plug (8), then fill with city w ater. 10. When the radiator is full, st Keep the engine running art the engine, and run it at low idle. at low idle for 10 minutes until the more than 90°C (194°F). n drain valve (7) and remove drain water temperature reaches 11. Stop the engine, then ope plug (8) to drain the water. 12. Close drain valve (7). Wind seal tapes onto drain plug (8), then tighten it. Install covers (2) and (4). 13. 14. Add coolant through the w ater filler port up to the mouth o f the port. For details of the C DENSITY TABLE". OOLANT density, see "COOLANT 15.

To bleed the air from the co oling system, run the engine a t low idle for 5 minutes, and fo r a further 5 minutes at high idle. e radiator cap off.) idle. (When doing this, leave th 16. Drain the water from sub t ank (9), wash the inside of the sub tank, then add cooling wa ter to a point midway between the FULL and LOW marks. 17. Stop the engine, wait for ap proximately 3 minutes, add coolant up to the mouth of the filler p ort, and tighten the radiator ca p (6).