Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE Adjustment WARNING 4 - 26 CHECK AND ADJUST TRACK TENSI (Machine eq uipped with steel shoes, road The wear of the pins and bushings on the undercarriage will vary orking c onditions and type of soil, so inspect the t rack tension frequently in ord er to maintain the standard tension Stop the ma chine on firm, horizontal grou nd when carrying out the inspectio n and m Checking engine at low idle, move the machine forward a 1. Run the distance machine 2. Choose roller (2) 3. Measure the track Stand Deflec 1. Run the equal to the length of track o n ground, then stop the . 2.

Choose wooden block (3) that will reac h from idler (1) to carrier , then place it on top of the tr ack. ween the top surface of e wooden block. m (0.4 to 1.2 in). 3. Measure the maximum deflection bet and the bottom surface of th ard deflection tion "a" should be 10 to 30 m If the track t ension is not at the standard v alue, adjust it in the following man There is dange grease. Never r of plug (4) flying out under the h loosen plug (4) more than 1 turn igh internal pressure of the . Never loosen mounting dire any part other than plug (4). N ction of plug (4).

nsion cannot be loosened with ever put your face in the the procedure given here, If the track te please contac t your Komatsu distributor. Increasing Track Tension Prepare a grease pump. Prepare a gr 1. Pump in 2. To chec idle, mov of track 3. Check th adjust it 1. Pump in grease through grease fitting (5) with a grease pump. 2. To chec k that the track tension is corre ct, run the engine at low e the machine forward a dist on ground, then stop the mac ance equal to the length hine. e track tension again, and if the tension is not correct, again.