Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Loosening Track Tension WARNING 4 - 27 4. Continue to pump in grease until dimensio n (S) be comes zero (0) . If the tension is still loose, the pin and b ushing are excessively worn, s o they must be either turned or replaced. Please contact your Komatsu distributor fo r repair It is extremely dangerous t o release the grease by a ny meth od exce pt the If track tension is not relie ved by this procedure, co ntact yo ur Komatsu 1. Loosen plug (4) gra dually to release the g rease. e turn. 2. When loosening plu g (4), turn it a maximu m of on 3.

If the grease does n forwards and backw ot come out smoothly, ards a short distance. move the machine 4. 5. Tighten plug (4). To check that the tra ck tension is correct, run the engine at low idle, move the mach ine forward a distance equal t o the le ngth of track on ground, then stop the machine . 6. Check the track ten sion again, and if the te nsion is not correct, adjust it again.