Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE a of Adjustment WARNING Increasing Track Tension 4 - 30 CHECK AND ADJUST RUBB ER SHOE TENSION hoes) (Machine equipped with rubber s The wear of the rubber shoe will v ary with the work conditions an d typ e of soil, so inspect t he wear and track t ension whenever necessary. Stop the maintenance. machine on firm, horizontal ground when carrying out the inspection and In pa rticular, on new machines or after new tracks have been ins talle d and the tension ha s been s et to the sp ecified valu e, the track tension will beco me loose in the first 5 to 30 ho urs w hen the machine ha s been used for a certain amo unt of repeated travel.

If the track tension is adjusted frequently until the i nitial loose ning no l onger occu rs, this will prevent the shoes from comi ng off due to insufficient track t ension. If op erations are carried out when the rubber shoe is loose, the track will come off and it will caus e prematur e wear of th e core. Checking 1. Run the engine at low idle distance equal to the length machine. 2. Choose wooden block (3) tha roller (2), then place it on top 3. Measure the maximum defle the rubber shoe and the bott Standard deflection Deflection "a" should be 1 , move the machine forward 1. 2. r 3. t distance equal to the length of track on ground, then stop t machine.

Choose wooden block (3) tha t will reach from idler (1) to carr oller (2), then place it on top of the track. ction between the top surface Measure the maximum defle he rubber shoe and the bott om surface of the wooden bloc Standard deflection to 3 mm (0.039 to 0.118 in). Deflection "a" should be 1 If th e track tension is not at the s tandard value, adjust it in the f ollowing mann Ther of th e is danger of the plug (4) flying e grease. When loosening plug (4 out under the high internal press ), never loosen it more than one tu Neve the m r loosen any part other than plug ount of plug (4). (4).

Never put your face in line w If the Rubber shoe tension is not relie ved by this procedure, please cont your Komatsu distributor. NOTI The standard value is low, so be care ful not to tighten the rubber shoe too m