. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Loosening Track Tension WARNING given below. If the track tension is not 4 - 31 Prepare a grease 1. Pump in greas e through grease fitting (5) wi th a grease p ump. To check that t idle, move the he track tension i machine forward s correct, ru a distance n the engine equal to the l at low ength of track on gro Check the rub und, then stop th ber shoe tension e machine. again, and i correct, adjust 4. If the tension i s still low after su pplied greas e, the rubber shoe needs to be r eplaced or the se al in the cyl inder needs replaced. Ask your Komatsu di stributor for r eplacement.
It is extremely dang erous to release th e grease by a ny method ex cept the procedu relieved by this proc edure, please conta ct your Koma tsu distributo r. 1. Loosen plug ( 4) gradually to rel ease the gre ase. of one turn. 2. When looseni ng plug (4), turn it a maximum of one turn. 3. If the grease d forwards and b oes not come ou ackwards a shor t smoothly, t distance. move the machine 4. 5. Tighten plug ( To check that t 4). he track tension is correct, run the engine at low idle, move the machine forward a distance equal to the l ength of track on gro und, then stop th e machine. 6. Check the rub ber shoe tension again, and i f the tension is not correct, adjust it again.
REPLACE ROA D LINERS d with road liner) g all the road liner for the machine, please contact your Komatsu distributor to have the rried out. (Machine equippe d with road liner) When replacin replacement ca When replacing only part of the ro ad liner, use the special r oad line r remov al tool. Pleas e order th e tool fro m your Komatsu distrib utor.