Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 37 8. Fit tooth (1) to adap ter (4), and confirm that when th e pointer is pressed strongly, t teeth (1) is at the s pin of the adapter ( If the rear face of t the rear face of the in. If this happens, the from fitting comple remove the obstru adapter (4), knock he rear face of the hole for the pin of the ame level as the rear face of the hole for the 4). he pin hole of tooth (1) protrude s in front of pin hole of adapter (4), do not kn ock the pin re is something (C) preventing t he tooth (1) tely in adapter (4), locate the pr oblem and ction. When tooth (1) fits completely in in lock pin (2). 9.

Insert lock pin (2) in the pin hole in the tooth (1), and knock it in so that the top surf surface of tooth (1) ace of lock pin (2) is the same h eight as the . ucket tooth, always check the following. 10. After replacing a b ucket tooth, always check the fo 1) After the lock check that it is 2) Lightly hit lock was hit in. 3) Lightly hit the ti hit its sides fro 4) Confirm that ru shown in the fi pin (2) has been knocked in completely, secured by the teeth (1) and su rface. pin (2) in the reverse direction fr om which it p of the teeth (1) from above and below, and m right and left. bber pin lock (3) and lock pin (2 ) are set as gure.

The life of the teeth (1) can be lengthened and the frequ ency of its replacement ca n be redu ced by turning i t upside down so that it will wea r evenly. Replace the rubber pin lock (3) and locking pin (2) at the same time as replacing th e teeth (1). This makes it possible to prevent the teeth (1) from falling out.