Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) WARNING 4 - 38 Replace the b ucket tooth before the adapter s tarts to wear due to excessive wear of the too It is dangero us if the work equipment moves by mistake when the t eeth are being replaced. o the LOCK position. Set the work equipment in a stable condition, th en stop the engine and set t he l ock lever securely t The pins can be knocked o ut only with strong for ce, so there is a hazard that the pin may fly out. Che ck that there is no one in the surround ing area.

There is a ha zard that fragments will fly during th e replacement work , so always wear protective equi pment like safety glasses and gloves. 1. To make i t possible to knock out pin (1) o f tooth (2), put block (5) under the bottom o f the bucket, and se t so that the bottom surface of the bucket is horizontal. 2. Check tha t the work eq uipment is in a stabl e condition, then set the lock le ver to the L OCK 3. Place a b ar on the hea d of pin (1), hit the b ar with a hamme r to knock out the pin, the REMARK d bar of a diameter smaller than the pin.

t be removed in this way, to ensure safety, please Use a roun d bar of a d iameter smaller than I f it canno t be remove d in this way, to en contact yo ur Komatsu distributor and ask t hem to carry out the replaceme nt work.