. MAINTENANCE MAINTENANCE PROCEDURE then 13. Set valve (1) at the side of the fuel pre-filter cartridge to the open position (O). 14. After completing the replacement of filter cartridge (4), bleed the air. 4 - 70 9. When installing, apply oil to the packing s urface and bring the packing surface into contact with the seal s of filter cartridge (4) and then tighten it fu If the transparent cap is tightened too mu is not tightened enough, fuel will leak thro securely to the fixed tightening angle. 10. Clean the filter holder, fill the new filter c install to the filter holder. rther by 1/4 - 1/2 turns.
ch, the O-ring will be damaged and this will cause le akage of fu ugh the gap at the O-ring. To prevent these problem s, always t artridge with clean fuel, coat the packing surface thinly with oi NOTICE When adding fuel, do not remove cap (B). Alw small holes (A) on the dirty side. After adding fuel, remove cap (B) and install th Always fill with clean fuel. Be careful not to let the fuel. In particular, center portion is the clean cap (B) when adding fuel. Be careful not to let di portion on the clean side. 11. When installing, tighten until the packing surface contacts the seal surface of the filter holder, t hen tighte of a turn.
If the filter cartridge is tightened too far, t filter cartridge is too loose, fuel will also l When tightening with a filter wrench, b he packing will be damaged and this will lead to leakage of fuel eak from the packing, so always tighten the correct e extremely careful not to dent or damage the filter. 12. Check that the drain valve (2) is tightene Bleed the air as follows: where the float is at the highest position). 15. Fill the fuel tank with fuel (to the position 16.
Loosen the knob of feed pump (6), pull it out, then pump it in and out until the movement becomes hea REMARK It is not necessary to remove the plug at t After the engine runs out of fuel, use the same procedure to operate feed pump (6) and bleed 17. After finishing the air bleeding, push in th e knob of feed pump (6) and tighten it. e engine and run it at low idling for 10 minutes. 18. After replacing the filter cartridge, start th Check for leakage of oil from the filter sea tightening of the filter cartridge. If there is still oil leakage, repeat Steps foreign material in the packing surface is it. l surface and tranparent cap mounting.
If any oil is le aking, che 2 - 6 to remove the filter cartridge, and if any damage or emb found, replace it with a new cartridge and repeat Ste ps 7 - 17 to