. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT NOTICE on the ground. Close the crusher the work pedal (if 4 - 90 Carr y out the following procedure to operate the work equipmen t control leve r fully to the front, rear , left, and right within 15 seconds of st opping th e engine. Whe n the eng ine stops, the pressur e in th e accumulator gradually goes down, s o the pressure can only be released immediately after the engi ne is stopped. 1. Place th e work e attachm ent jaws, etc 2. Stop the engine. 3. Turn the starting switch to t he ON position (B) 4.
Set the lock leve r to t he FR EE position (F), the n operat e each work eq uipment control lev er and attachment control p edal (if equippe d) fully t o the front, rear, cuit. left, righ he pressur e in the h ydraulic cir 5. Set the lock leve r to the L OCK p osition ( L) t o lock equipm ent control levers and attachment control d). ttachmen ontrol equippe