Komatsu — ADJUSTING STRAIGHT TILTDOZER

TESTING AND ADJUSTING MEASURING OUTPUT PRESSURE OF PPC VALVE 2. Procedure for adjusting shims when assembling blade 1) After assembling the blade, adjust the clear- ance at tilt portion (2), center portion (4) and trunnion portion (5) with shims. Shim adjustment 2) Grease each place to be adjusted, and check that it rotates smoothly. 2 Adjustment portions (2), (3), (4): Grease (G2-L1) 3. Adjust center brace 1) Adjust with shim (6) so that clearance d of ball joint (5) is as shown below. Clearance d : 0.2 – 0.5 mm 014012 2) Loosen bolt (7). 3) Operate the blade control lever to raise the blade off the ground. ¤ After doing this, lock the blade control lever securely with the safety lever.

4) Insert a bar in hole (8) of the center brace, and rotate it in the direction to increase the tension. fl Adjust so that clearance e between the track and frame is uniform on the left and right. fl Adjust the tension of center brace (9) with the blade raised above the ground, and tighten to the following tightening torque. 3 Center brace: 36.78 ± 12.26 Nm {3.75 ± 1.25 Nm} 5) Adjust dimension C of the center brace as follows. Standard dimension C : 995 mm 20-122-2 I Place to adjust Item Tilt portion (2) Center portion (3) Lift portion (4) Trunnion portion (5) Clearance a b c d Standard clerance 0.2 – 0.5 0.2 – 0.5 0.2 – 0.5 0.2 – 1.0 Standard shim thickness 5 5 4 10