hitachi — MC Fault Code 11101

TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11101 Fault Code Influenced Control 11101-3 Engine Control Dial Control 11101-4 Engine Control Dial Control Disconnect connector of MC. Check for continuity in harnes between terminal #C1 of harness end of connector MC-C in MC and terminal #2 in switch panel. Open circuit in harness between MC and engine control dial. YES YES To A Insert a probe of tester from the back of connector in terminal #2 with switch panel connector connected. When rotating engine control dial, chack if voltage becomes specification. Disconnect connector of switch panel. Check if resistance between terminals #1 and #2 of switch panel end of connector is 5 ± 0.5 k Ω .

NO Check if voltage between terminal #1 of harness end of connector in switch panel and machine is specification. Open circuit in harness between MC and engine control dial (terminal #3). · Key switch: ON YES NO Open circuit in harness between MC and engine control dial (terminal #1). · Key switch: ON · Specification: 5 ± 0.5 V NO NO Faulty engine control dial. · Specification: Refer to the table below. Specification of Engine Control Dial Connector (Harness end of connector viewed from the open side) MC Connector MC-C C1 #C1 C10 C23 C31 Switch Panel #3 #2 #1 T5-5-74 Trouble Cause Abnormal Engine Control Dial Sensor High Voltage Voltage:

4.78 V or higher Abnormal Engine Control Dial Sensor Low Voltage Voltage: Less than 0.22 V Check if voltage between terminals #1 YES and #3 of harness end of connector is 5±0.5 V. YES Faulty MC. Check if voltage be- tween terminal #C1 of A harness end of con- nector MC-C and Shorted circuit in machine is 0 V. harness between MC · Key switch: ON NO and engine control dial. YES Faulty MC. Shorted circuit in harness between MC and engine control dial. Slow Idle 0.3 to 1.0 V Fast Idle 4.0 to 4.7 V