TROUBLESHOOTING / Troubleshooting B YES To A Disconnect connector in pressure sensor (travel). Check if voltage be- tween terminals #1 and #3 of harness end of connector is 5 ± 0.5 V. YES Check if voltage be- tween terminals #C2 of harness end of connector MC-C and machine is 0 V. Shorted circuit in harness between MC and pres- sure sensor (travel). NO · Key switch: ON Switch pressure sen- sor (travel) with other pressure sensor. Check if fault code for switched pressure sensor is displayed. NO YES · Key switch: ON Check if voltage be- tween terminals #1 of harness end of con- nector in pressure sensor (travel) and machine is between 0.25 and 4.75 V.
YES Open circuit in harness between MC and pres- sure sensor (travel) (ter- minal #3). NO Open circuit in harness between MC and pres- sure sensor (travel) (ter- minal #1). · Key switch: ON NO Faulty pressure sensor (travel). YES Shorted circuit in harness between MC and pres- sure sensor (auxiliary). NO YES Disconnect connector in maximum pump 1 flow rate limit control solenoid valve. Check if current be- tween terminals #1 and #2 of harness end of connector is be- tween 56 mA and 920 mA. Check for continuity in harness between MC and maximum pump 1 flow rate limit control solenoid valve. A · Key switch: ON Faulty MC.
NO · Between terminal #A3 of connector MC-A in MC and terminal #1 of connector in maxi- mum pump 1 flow rate limit control solenoid valve · Between terminal #A20 of connector MC-A in MC and ter- minal #2 of connector in maximum pump 1 flow rate limit control solenoid valve Open circuit in harness between MC and maxi- mum pump 1 flow rate limit control solenoid valve. NO T5-6-119 YES Faulty maximum pump 1 flow rate limit control so- lenoid valve.