TROUBLESHOOTING / Troubleshooting B Improper gap between amature and rotor (improper air gap). Replace. Open or shorted circuit in core cable. Shaft does not rotate (internally locked). Replace. Faulty Electrical System. Faulty Electrical System. Oil leaks from mechanical seal, gasket, and/or charge valve. Oil leaks from oil plug. Replace. Oil and refrigerant leaks from front housing, and/or cylinder block joint. Replace. Normal leaks from hoses. Charge refrigerant. No leaks (normal). Refer to the Cooling Circuit Troubleshooting Table on page T5-6-136. Blown gasket (Refer to NOTE 3 on page T5-6-151.) Replace. Check and adjust oil level. Excessive oil. T5-6-149 Seized clutch. Replace.
Broken valve (Refer to NOTE 3 on page T5-6-151.)