hitachi — Other System Troubleshooting

TROUBLESHOOTING / Troubleshooting B Broken clutch bearing due to overly tightened belt. Replace. Shaft does n’o rotate. Replace. Shaft rotates draggy. Broken clutch bearing. Contact or slip due to poor air gap. Replace. Faulty idle pulley bearing. Saggy belt. Refer to the Cooling Circuit Troubleshooting Table on page T5-6-136. Loose screws. Broken valve. Replace. Blown gasket. Replace. Vibration due to saggy belt. Refer to the Cooling Circuit Troubleshooting Table on page T5-6-136. NOTE: 1. Do not quickly decide that oil is leaking when a stain around the clutch and/or gasket is found. A slight oil seepage will appear due to the seal construction.

However, this oil seepage will not cause malfunction. Accurately check whether oil is leaking or seeping only. 2. When gas detector is used in the high sensitivity range, normal gas leaks from rubber hose sur- face may be detected. As long as the specified rubber hoses are used, the problem should not occur. (In case a large leaks is detected, the hose may be broken.) 3. After allowing the compressor to idle for 10 to 15 minutes, normal pressure difference between high-pressure side and low-pressure side is 0.5 MPa (5 kgf/cm 2 ) or less. When the clutch is turned OFF, the pressure difference between high-pressure side and low-pressure side will dis- appear within about 10 seconds.

T5-6-151 Abnormal internal noise. Loose screws.