hitachi — Voltage and Current Measurement

TROUBLESHOOTING / Electrical System Inspection 5 Voltage Circuit Voltage between terminal #1 and the vehicle frame Disconnect the connector with the key switch OFF. Measure voltage between terminal #1 on the machine harness end connector and the vehicle frame (ground). Key switch: ON Tester black terminal (negative): Connected to the vehicle frame (ground) Tester red terminal (positive): Connected to terminal #1 Evaluation: If the measuring voltage is within 5 ± 0.5 volts, the circuit up to terminal #1 is normal. Voltage between terminal #1 and the ground terminal Disconnect the sensor connector with the key switch OFF.

Measure voltage between terminal #1 on the machine harness end connector and the ground terminal (terminal #2 for two polarities, or terminal #3 for three polarities). Key switch: ON Tester black terminal (negative): Connected to the ground terminal (terminal #2 or #3) Tester red terminal (positive): Connected to terminal #1 Evaluation: If the measured voltage is within 5 ± 0.5 volt, the circuit up to terminal #1 or the ground terminal (terminal #2 or #3) is normal. 1 2 V T107-07-05-006 T107-07-05-007 1 2 T107-07-05-008 1 2 3 T107-07-05-009 T5-7-16 Power Signal or Two Polarities Source Ground Power T hree Polarities Source Signal Ground T wo Polarities T hree Polarities