Yamaha Motor Corporation, USA 9.9A/15A — Yamaha Motor Corporation, USA 9.9A/15A User Manual

E [How to remove propeller] 1) Using the pliers provided, straighten the cotter-pin and pull it out. 2) Remove the propeller nut. 3) Remove the propeller. 1 Thrust washer 2 Propeller 3 Washer 4 Propeller nut 5 Cotter pin 602052 [How to install propeller] 1) Apply Yamaha Marine grease D or Marine grease (water-resistant grease) to the propeller-shaft. 2) Slide the propeller over the propeller- shaft. c C 5 3 4 1 2 Be sure to install the thrust washer before installing propeller, otherwise, lower case and propeller boss may be damaged. 602042 3) Tighten the propeller nut to the speci- fied torque. Tightening torque:

Refer to SPECIFICATIONS, Page 4-1 4) Align the propeller nut with the pro- peller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends. NOTE: When the propeller nut does not align with the propeller shaft hole after tighten- ing to the specified torque, then tighten it more to align the hole. c C Be sure to use a new cotter pin and bend the ends over securely. Otherwise, the propeller could come off during operation and be lost. 602053 4-17