Caterpillar — Caterpillar 99709-68120 — user manual

12 12-13 Oil Pressure Measurement Service standards Unit: MPa (kgf/cm2) [psi] Location Maintenance item Standard value Limit Remedy – Oil pressure [at oil temperature 70 to 905 °C (158 to 194 °F)] At no-load minimum speed 0.1 (1.0) [14.5] or higher Up to 0.1 (1.0) [14.5] Adjust At no-load maximum speed 0.2 to 0.6 (2.0 to 6.1) [29.0 to 87.0] Up to 0.2 (2.0) [29.0] Tightening torque Unit:

N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Engine oil pressure gauge unit 15 to 22 (1.5 to 2.2) [11.1 to 16.2] Check with engine cold Sealant Location Points of application Kinds Quantity 1 Wrap around thread of engine oil pressure gauge unit Teflon tape 3 1/2 turns • Remove engine oil pressure gauge unit 1. 16773 • Fit adapter 3 onto the engine oil pressure gauge unit mounting, then fit the oil pressure gauge onto the adapter. • Warm up the engine until the oil temperature reaches 70 to 90°C (158 to 194°F). • Measure the oil pressure at no-load minimum speed and at no-load maximum speed.

If the measured values are below the specified standard values, overhaul the lubrication system. • After taking measurements, fit oil pressure gauge unit 1 and tighten it to the specified torque. 16774 NOTE Oil pressure gauge unit 1 must be fitted with the engine cold.