INJECTION PUMP DRIVE G Disassembly sequence 1 Eyebolt 2 Oil pipe 3 Injection pump drive assembly 4 Nut 5 Lock washer 6 Drive gear 7 Collar 8 Bolt 9 Pin 10 Coupling 11 Bolt 12 Cover 13 Bolt 14 Bearing 15 Bearing holder 16 Pump drive shaft 17 Pump drive case * : Injection pump assembly P.13-22 G Assembly sequence Reverse the order of disassembly. 01918 Service standards Unit: mm (in.) 13-24 Location Maintenance item Standard value Limit Remedy 16 Pump drive shaft end play – 0.59 (0.0232) Replace 16, 17 Pump drive shaft-to-pump drive case clearance – 0.12 (0.00474) Replace pump drive case Tightening torques Unit:
N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Eyebolt 21 (2.1) [15.5] – 4 Nut (drive gear mounting) 167 to 211 (17 to 21.5) [123 to 156] – 8 Bolt (coupling mounting) 30 to 36 (3.1 to 3.7) [22.1 to 26.6] – 11 Bolt (cover mounting) 25 to 29 (2.5 to 3) [18.4 to 21.4] – 13 Bolt (bearing holder mounting) 5.9 to 6.9 (0.6 to 0.75) [4.35 to 5.09] –