Caterpillar — Caterpillar 99709-68120 — user manual

13 N Service procedure Installing injection pump drive assembly Bring cylinder No. 1 of the engine to the TDC position of its compression stroke. Gr. 11 Align the inscribed line A on the drive gear 6 of the injection pump drive assembly 3 with the inscribed line A on the pump drive case 17 . 3 01919 Remove the plug C from the flywheel housing B , then check that the inscribed line A on the drive gear 6 is aligned with the pointer D . If the line and pointer are not aligned, remove and refit the injection pump drive assembly. 01920 to Installing drive gear Fit the drive gear 6 such that its “0” alignment mark is aligned with the “0” alignment mark on the pump drive shaft 16 .

Then, fit the lock washer 5 such that its notch A is aligned with the drive gear alignment mark, and tighten the nut 4 to the specified torque. 6 4 01921 When the assembly is complete, bend the lock washer 5 down onto the nut 4 . 01922 13-25