INJECTION NOZZLE G Inspection before disassembly P.13-29 G Disassembly sequence 1 Eyebolt 2 Fuel leak-off pipe 3 Injection pipe 4 Bolt 5 Injection nozzle assembly 6 Connector 7 Cap nut 8 Adjusting screw 9 Spring 10 Push rod 11 Retaining nut 12 Nozzle 13 Needle valve 14 Pin 15 Nozzle holder 16 Dust seal 17 Gasket : Non-reusable part Repair kit: Nozzle Service Kit G Assembly sequence Reverse the order of disassembly. 04555 WARNING To minimize the risk of fire, wipe up any spilled fuel. CAUTION Under no circumstances change the needle valve 13 and nozzle 12 combination used in each injection nozzle assembly 5.
NOTE Clean off any carbon deposits before disassembling, reassembling, or adjusting the injection nozzle assembly 5. Before disassembly, check the pressure and shape of the spray and inspect the assembly for fuel leaks. If no abnormality is apparent, do not commence disassembly. When fitting the injection nozzle assembly 5, tighten each of the two bolts 4 a little at a time. 13-28