Caterpillar — Caterpillar 99709-68120 — user manual

ON-VEHICLE INSPECTION AND ADJUSTMENT 14-6 Replacing Coolant and Cleaning Coolant System 1 Pressure cap 2 Crankcase drain plug 3 Radiator drain cock 16941 16942 Tightening torques Unit: N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 2 Crankcase drain plug 115 (12) [84.8] – Using the radiator for extended periods without cleaning the cooling system will cause overheating since rust and scale deposits will accumulate. The cooling system must be cleaned periodically. G Draining coolant Before draining the coolant, loosen pressure cap 1 to reduce the pressure in the cooling system.

WARNING • To avoid being scalded, ensure that the coolant has cooled sufficiently before draining it out. • Unless care is exercised, opening pressure cap 1 when the coolant is hot can cause the coolant to spray out. Cover the pressure cap with a cloth, and loosen the cap slowly to bleed off the pressure before opening it fully. G Cleaning procedure • Run the engine and keep the coolant at a temperature of approximately 90°C (194°F) so that the thermostat valve remains open and the coolant continues to circulate in the radiator. • To increase the coolant temperature quickly, cover the front of the radiator with cardboard or a similar material.

• If cleaning is carried out after a large amount of rust has accumulated, the radiator may start to leak. Carefully examine the radiator for leaks after cleaning the cooling system. • Soft water to be used should have the following properties. CAUTION Do not use hard water as it causes scale and rust. Required propertiies of soft water Total hardness 300 ppm or less Total dissolved solids 500 ppm or less Sulfate SO− 4 100 ppm or less pH 6 to 8 Chloride Cl− 100 ppm or less – –