Caterpillar — Caterpillar 99709-68120 — user manual

ON-VEHICLE INSPECTION AND ADJUSTMENT Air Bleeding of Cooling System Remove the pressure cap. Keeping the coolant temperature at 90°C (194°F), let the engine idle until the cooling system is completely bled of air. While the engine is idling, keep the heater controller's adjustment lever at its maximum-temperature position so that coolant flows freely in the heater piping. After bleeding the cooling system of air, add coolant to the radiator and reservoir tank as required. Gas Leak Testing The presence of air or exhaust gas in the coolant increases corrosion and rust in the cooling system. Check for air or exhaust gas in the coolant using the following procedure: Remove pressure cap 1 .

WARNING Make sure the coolant is sufficiently cool before loosening the pressure cap. If the coolant is hot, it will spray out. Run the engine until the coolant temperature reaches approximately 90°C (194°F). If bubbles A appear continuously, there is air or exhaust gas in the coolant. If the coolant contains air, the cylinder head bolts, water pump mounting bolts, or hose connections may be loose. Alternatively, the hoses may be damaged. If the coolant contains exhaust gas, it is possible that the cylinder head gasket is damaged or that the cylinder head is cracked. 00187 14-8