14 G Use of belt tension gauge Set upper O-ring E of Belt Tension Gauge to 8 N (10 kgf) [1.80 lbf] (push load) on scale F . Set lower O-ring G of Belt Tension Gauge to the V-belt's correct maximum deflection value on scale 03613 Apply the Belt Tension Gauge to the center of V-belt 1 and push until O-ring E reaches the flange K . 03614 Measure the extent of V-belt 1 deflection A . If the measurement does not conform with the standard value, adjust the V-belt as shown below. 03615 [Adjustment] Adjust the V-belt tension as follows: Loosen alternator mounting bolts L (2 places) and adjust the V-belt tension by moving alternator M to the left or right.
When the adjustment is complete, tighten the bolts and nuts securely. CAUTION Excessive tension in V-belt 1 may damage the belt and related bearings. Be sure to replace the V-belts 1 as a set to maintain even tension between them. Keep V-belt 1 free of oil. If the belt becomes oily, it will slip, resulting in overheating of the engine and insufficient charging of the battery. 00203 14-13