54 N Service procedure Inspection of alternator (1) Inspection of performance of alternator (Inspection by test bench) Wire the alternator 3 as shown. A: Ammeter B: Alternator terminal B C: Switch D: Switch E: Alternator terminal E F: Load resistance (variable resistance) G: Alternator drive motor V: Voltmeter R: Alternator terminal R 3 Increase the load resistance F to a maximum (where practically no load current flows). Set the switch C and switch D to ON. Let the alternator 3 warm up at 5000 rpm for 30 minutes. Adjust the load resistance F so that the current will have the nominal value. Nominal value of alternator current:
Measure the current with the alternator 3 at each of the specified speeds. If the reading is out of the standard value, disassemble and check the alternator 3 . P.54-26 16132 24V–40A (2) Inspection of performance of regulator (Inspection by test bench) Wire the alternator 3 as shown. A: Ammeter B: Alternator terminal B C: Switch E: Alternator terminal E G: Alternator drive motor L: Alternator terminal L R: Alternator terminal R V: Voltmeter Set the switch C to ON. Let the alternator 3 rotate at a low speed. Increase the rotating speed of the alternator 3 to 5000 rpm and measure the voltage (regulated voltage). At the same time, check to ensure that the current value is 5A or less.
If the readings are out of the standard values, proceed as described below. If the readings exceed the standard values, replace the regulator (built in the alternator 3 ). If the readings are below the standard values, check all the parts of the alternator before replacing the regulator. 16133 54-25