Caterpillar — Caterpillar 99709-68120 — user manual

54 54-33 CAUTION • To remove the yoke & brush holder assembly 11, first raise the brushes 14 and 15 from the brush holder assembly 16 to prevent damage to the commutator of the armature 22. • Do not remove the bearings 20 and 30 unless they are found to be defective. • When the yoke & brush holder assembly 11 is removed from the front bracket assembly 25, be careful not to allow the armature assembly 18 to fall. • When the armature assembly 18 is removed, the ball 19 may simultaneously come out. Be careful not to lose it. • When the motor section only is to be disassembled and checked like when the brushes and surrounding areas are to be checked, the pinion 3 need not be removed.

• Except in the above case, the pinion 3 must be removed before disassembly of the individual portions. G Reassembly sequence Reverse the order of disassembly. CAUTION When the magnet switch 5 was replaced, be sure to adjust the pinion gap. G Inspection after reassembly P.54-34 Service standards Unit:

mm (in.) Location Maintenance item Standard value Limit Remedy – Pinion gap 0.5 to 2.0 (0.0197 to 0.0787) – Adjust – No-load characteristics During 23V supply Current 85A or less – Check Rotating speed 3300 rpm or more – 13 Spring pressure of brush spring 29 to 39 N (3 to 4 kgf) [6.52 to 8.77 lbf] 20 N (2 kgf) [4.50 lbf] Replace 14, 15 Brush length 18 (0.709) 11 (0.433) Replace 18 Outside diameter of commutator 32 (1.26) 31.4 (1.24) Replace Commutator outer circumferential runout – 0.05 (0.00197) or more Depth of mica between segments – 0.2 (0.00787) or less Repair or replace Lubricant Location Points of application Kinds Quantity 5 Apply to lever contacting portion of magnet switch MULTEMP PS-2 As required 10 Apply to conical washer MULTEMP PS-2 As required 19 Apply to ball MOLYCOAT ® AG650 As required 18, 33 Apply to teeth of gears of amature assembly and planetary gears MOLYCOAT ® AG650 As required 27 Apply to overrunning clutch sliding surfaces of lever MULTEMP PS-2 As required 35 Apply to washer MOLYCOAT ® AG650 As required 36, 38 Apply to sliding surfaces of gearshaft assembly and overrunning clutch assembly MULTEMP PS-2 As required 18, 36 Apply to sliding surfaces of gearshaft and armature assembly MOLYCOAT ® AG650 As required 38 Apply to splined portion of overrunning clutch MULTEMP PS-2 As required