STARTER Pinion [Removal] To remove the pinion 3 , it is necessary to supply current to the starter and let the pinion spring out. 3 CAUTION When current is supplied to the starter, the pinion 3 will spring out and rotate. Be careful not to touch it by hand. The magnet switch 5 may be very hot after the end of inspection. Be careful when you touch it. The time during which current is supplied to the starter should be limited to 10 seconds or less on the pull-in coil P side and 30 seconds or less on the holding coil H side. If current is supplied to the coils for a longer period, the coils will be overheated and baked.
Make sure that the pinion 3 is made to spring out by supplying current to the starter. If the pinion is forced out by pulling the lever 27 without supplying current to the starter, the front bracket 32 and lever could be damaged by the impact produced when the stopper ring 1 is removed. When current is supplied to the starter, a large current that exceeds 100A will flow. When the starter is inspected, therefore, use thick cables like booster cables. Check to ensure that all the connections are tight and secure. 14267 14257 Wire the starter as shown. A: Switch B: Starter terminal B C: Switch D: Cable M: Starter terminal M S:
Starter terminal S 10768 The following operations are performed by supplying current to the starter. It is therefore necessary that the series of operations up to removal of the pinion 3 is completed in less than 30 seconds. Set the switch A and switch C to ON to supply current to the starter. At the time, the pinion 3 will spring out and rotate. 14259 54-36