Caterpillar — Caterpillar 99709-68120 — user manual

54 (2) Pinion gap [Inspection] Wire the starter as shown. C: Switch D: Switch E: Cable M: Starter terminal M S: Starter terminal S 10768 The following operations are performed by supplying current to the starter. It is therefore necessary that the series of operations up to completion of measurement of the pinion gap is completed in less than 30 seconds. Set the switch C and switch D to ON to supply current to the starter. At the time, the pinion 3 will spring out and rotate. 14259 Immediately (in less than 5 seconds) after the pinion has started rotation, set the switch D to OFF stop rotation of the pinion.

CAUTION When the switch C and switch D are set to ON, current is supplied to both the pull-in coil P and holding coil H. Since wiring is such that no voltage is applied to terminal B of the starter, current flows to the pull-in coil during rotation of the pinion 3. To prevent baking the pull-in coil, therefore, it is necessary that the switch E is set to OFF immediately (in less than 5 seconds) after the pinion has started rotating. 14260 Lightly push the end of the overrunning clutch 38 in and measure the amount F the clutch moves in the axial direction (pinion gap). Set the switch C to OFF to stop supplying current to the starter.

If the reading is out of the standard value, adjust by the following procedures. 10769 [Adjustment] Remove the magnet switch 5 from the front bracket assembly 25 . Adjust by changing the thickness of shim 6 . Increasing the number of shims reduces the pinion gap F . Types of shims: 0.25 mm (0.00984 in.), 0.5 mm (0.0197 in.) 10770 54-35