ON-VEHICLE INSPECTION AND ADJUSTMENT 11-8 Measuring Compression Pressure Service standards Location Maintenance item Standard value Limit Remedy – Compression pressure Each cylinder (at 200 rpm) 2550 kPa (26 kgf/cm2) [370 psi] 1960 kPa (20 kgf/cm2) [284 psi] Inspect Cylinder-to-cylinder pressure difference – 390 kPa (4 kgf/cm2) [56.6 psi] Inspect Special tools Unit: mm (in.) Location Tool name and shape Part No. Application – Compression Gauge Adapter 01942 MH061461 Measuring compression pressure Reductions in compression pressure should be used as a guide in determining the timing of engine overhauls.
Take measurements regularly and keep track of changes; an overview of pressure variations can be useful in fault diagnosis. During the engine's run-in period and after parts have been replaced, the compression pressure will increase slightly as piston rings, valve seats, and other parts fit snugly in position. The pressure will then normalize as parts wear. • Before inspections, check that the engine oil, starter, and battery are normal. • Warm up the engine until the coolant temperature reaches 75 to 85°C (167 to 185°F). • Turn off all lights and auxiliary devices. • Remove the injection nozzle A.
Gr 13 CAUTION Cover the mounting holes and injection pipes to prevent the entry of dust and dirt. 01938