Caterpillar — Caterpillar 99709-68120 — user manual

11 11-13 ervice standards Unit: mm (in.) Location Maintenance item Standard value Limit Remedy 12 Push rod runout – 0.4 (0.0157) Replace 13, * Tappet-to-crankcase clearance [Basic diameter: 31 mm (1.220 in.)] 0.06 to 0.10 (0.00237 to 0.00394) 0.2 (0.00787) Replace tappet Tightening torques Unit:

N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Joint 29 (3.0) [21.4] – 3 Rocker cover bolt 3.9 (0.4) [2.88] – 8 Cylinder head bolt (installation of rocker and bracket assembly and cylinder head and valve assembly) M14 bolt 78 (8) [57.5] + 180° • Wet • Can be reused up to 3 times M10 bolt 17 (1.75) [12.5] + 34 (3.5) [25.1] – Oils Location Points of application Kinds Quantity 2 Rubber seal of oil filler cap Engine oil As required 8 Threads of cylinder head bolts Engine oil As required 12 Both ends of push rods Engine oil As required 13 Outer surfaces of tappets Engine oil As required Special tools Location Tool name and shape Part No.

Application 10 Socket Wrench 01984 MH061560 Tightening cylinder head bolts (M14 bolt only) N Service procedure 10 Cylinder head and valve assembly [Removal] • Before loosening the cylinder head bolts 8, loosen the adjusting screw C on every rocker A that is compressing its valve spring B. 13021