CYLINDER HEAD AND VALVE MECHANISM Loosen and remove the cylinder head bolts 8 in the sequence shown. Each cylinder head bolt should be loosened a little at a time. 01945 [Fitting] The M14 cylinder head bolts 8 can be reused only three times. Before refitting the cylinder head bolts, make a punch mark on the head of each one to indicate times of reuse. CAUTION If any bolt already has three punch marks, it must not be reused any more; replace it with a new one. 01945 Tighten the cylinder head bolts 8 to the specified torque {M14 bolts: 78 N·m (8 kgf·m) [57.5 lbf·ft]; M10 bolts: 17 N·m (1.75 kgf·m) [12.5 lbf·ft]} in the sequence shown.
Then, turn the bolts further in accordance with the following procedure. * : Tighten together with rocker and bracket assembly ➀ to : M14 bolt (wet) to : M10 bolt Before fitting the Socket Wrench over a cylinder head bolt, turn the holder D counter-clockwise to tension the built-in spring. E : Socket F : Rod G : Rod (extension) 01991 Set the socket such that the built-in spring force forces the rod G against the rocker shaft bracket, an injection pipe, or another nearby part. On the holder D , select the inscribed line H that is easiest to see. Using the selected line as a reference, turn the socket E 180° clockwise.
(One gradation on the scale J represents 5°.) CAUTION 12825 Since the M14 cylinder head bolts 8 utilize the plastic region tightening method, they must not be tightened further after this procedure. 11-14